Physical Security
Terms
undefined, object
copy deck
- A permanent deviation from a specific security requirement
- Exception
- Any unit of the naval shore establishment
- Activity
- An armed force derived from host and tenant commands
- ASF
- Petty larceny
- Pilferage
- Corrective courses of action and expected dates of completion
- POA&M
- Principal advisor in matters pertaining to the security of classified information
- Security manager
- Offensive measures taken to prevent terrorism
- Counterterrorism
- All assets
- Property
- A real property entity
- Facility
- Responsible for the development of a command's physical security program
- Security Officer
- A written temporary relief
- Waiver
- A grouping of facilities
- Installation
- Who is ultimately responsible for security
- CO
- What instruction covers in detail how the security officer should perform his duties?
- OPNAVINST 5530.14
- The duties of a security department fall into a total of how many basic categories
- Five
- Regardless of its size or mission, each activity is required to have which of the following security commitees?
- PSRC (Physical Security Review Commitee)
- Who should act as the chairperson of the physical security review comittee?
- Security Officer
- What security comittee is designed to address security-related matters on an installation-wide perspective?
- PSRB
- Personnel selected as the command key control officer ideally should have a clearance equal to the highest level of classified material held at the command
- True
- Which personnel should NOT have access to a central key room
- Public works officer
- The lack of free play in a car ball end seal may indicate tampering. Approximately how much free play, in inches, should there be?
- 1/8
- How often should all unused seals be inventoried?
- Annually
- Which instructions outlines policy on quarterdeck inspections?
- OPNAVINST 3120.32
- Perimeter and area protective controls are the first steps in providing protection against certain security hazards
- True
- All security barriers are broken down into what two types?
- Natural and Structural
- Which security methods should be used to secure relatively small restricted areas within an installation?
- Enclaving
- An asset lost or stolen from this area would cause serious damage
- Level Two
- The most secure type of restricted area.
- Level Three
- Access to this area constitutes access to the security interest.
- Level One
- Never inside a level three area
- Level Two
- An asset stolen from this area would cause grave damage.
- Level Three
- Unescorted movement in this area could permit access to the security interest
- Level Two
- This area is the least secure type of restricted area
- Level One
- Access to this area is minimally controlled or uncontrolled
- Nonrestricted
- This type of area should no be located inside restricted areas.
- Nonrestricted
- This area may serve as a buffer zone for a level two area
- Level One
- Uncontrolled movement may or may not permit access to a security interest.
- Level One
- Which security areas are required to have the perimeter fence posted at no less than 100 feet intervals along the perimeter?
-
Level One
Level Two
Level Three - Which security areas requires that visitors be logged in and out during normal duty hours?
- Level Three
- During normal duty hours, the use of an access list and entry and departure log is suggested but not required for what security areas?
- Level Two
- What appendix of OPNAVINST 5530.14 lists facilities and assets that are critical and essential to the overall mission of the Navy?
- IX
- At a minimum, how often should administrative vehicle and personnel inspections operations be conducted?
- Weekly
- Which agencies has/have the authority to control access to certain limited waterway areas under its juridiction when security dictates
-
US Coast Guard
US Army Corps of Engineers - In which limited waterways areas may enforcement be delegated to the Navy Command?
- Restricted area
- The signs posted at points of ingress to restricted areas should be approximately what size?
- 3ft x 3ft
- The signs posted on perimeter barriers of restricted areas should be approximately what size?
- 12in. x 18in.
- The signs posted on perimeter barriers of nonrestricted areas should be approximately what size?
- 11in. x 12 in.
- The interval between signs posted along restricted and nonrestricted area perimeters should not exceed how many feet?
- 200
- During daylight conditions, signs should be legible from a distance of at least how many feet?
- 100
- The lettering in area perimeter signs should be black in color except for the word "WARNING" which should be red in color?
- True
- A light source that points toward likely avenues of approach and provides relative darkness for security personnel is called what type of lighting?
- Glare projection
- Two primary methods of continuous lighting are glare projection and controlled
- True
- What type of lighting is used to limit the width of a lighted strip outside a perimeter?
- Controlled
- What type of lighting is turned on automatically when activity is detected by an intrusion system?
- Standby
- What type of lighting is normally used to supplement continous lighting?
- Moveable
- Who decides what additional areas, if any, need illuminating at a command?
- CO
- How often should protective lighting be checked by security force personnel?
- Daily
- How often should emergency power system be tested?
- Monthly
- The test results of an emergency power system should be recorded for how many years?
- 3
- At least how often should an immediate superior in command conduct a physical security inspection?
- Every year
- The purpose of a physical security survey is to evaluate the adequacy of a command's security program
- True
- A physical security survey should be conducted during which times?
-
Normal working hours
Non-duty hours
Hours of darkness - Physical security surveys are management tools that are normally sent up the chain of command
- False
- A total of how many types of physical security surveys are used by the Navy?
- Three
- What type of physical security survey is conducted when changes occur that could affect the physical security of an installation?
- Supplemental
- The most positive method of identification
- Personal recognition
- The least reliable means for determining access authorization
- Military/dependent ID card
- Optional Form 55
- US Government ID card
- May be used to identify personnel who are authorized to nonrestricted areas
- Military/dependent ID card
- Required for level three areas
- Access list
- Used in areas where the number of authorized personnel does not exceed 50
- Personal recognition
- Should be maintained under stringent control
- Access list
- May be issued to civil service employees
- US Government ID card
- When if ever may an assigned escort leave a visitor alone in a security area
- Never
- How often should installations and activities re-badge all regular employees and other personnel possesing permanent picture badges?
- Every 6 years
- During normal daylight hours, the expiration date of a badge should be distinguisable from a distance of at least how many feet?
- Three
- All badges issued during a 6-year period ending December 1997 would normally bear a December 1997 expiration date.
- True
- A constractor picture badge may be issued for a what maximum period of time?
- 24 months
- The issuing activity should conduct an inventory of serialized badges or passes on hand at least how often?
- Semiannually
- The photo on a picture badge should be of what minimum size?
- 1in. x 1 1/4in.
- Which forms is used to identify and control motor vehicles on most installations?
- DD Form 2220
- What instruction provides guidance on the honoring of base decals issued by another activity?
- OPNAVINST 5560.10
- Which factors should be considered in determining the feasibility and necessity of installing IDS equipment?
-
Threat
Mission
Criticality - There are a total of how many basic types of instruction detection system?
- Four
- What type of instrusion detection system is pescribed for all naval activities and installations?
- Proprietary
- What instrusion detection system allows the intruder to know when the alarm is activated?
- Local Alarm
- What instrusion detection system is usually connected over leased telephone company lines?
- Central Station
- What instrusion detection system requires an arranged agreement prior to establishment?
- Police connection
- The sensor subsystem is divided into a total of how many areas?
- Two
- What is the normal power requirement for an intrusion detection system?
- 115 volt AC
- Only standard equipment intrusion detection system, which have a normal life-span of about 10 years, should be purchased.
- True
- When batteries are used as emergency power for intrusion detection systems, the batteries should last for a minimum of how many consecutive hours?
- 4 hours
- How often should all intrusion detection system be tested?
- Monthly
- How often should randomly selected sections of perimeter intrusion system be tested?
- Daily
- OPNAV/CMC sites commonly involve both interior and exterior sensors subsystems. What is the name of the alarm?
- Electro 46 optical alarm