Neve V3 (copy)
Terms
undefined, object
copy deck
- In record mode, the channel is routed to which fader?
- Large Fader
- In record mode, the channel is routed to which matrix?
- Large matrix
- In record + fader swap mode, the channel is routed to which fader?
- Small Fader
- Which matrix is used to route to tape?
- Large Matrix
- Which of the following buttons changes which signal feeds which matrix?
- Lower C/O (Changeover)
- The "bounce" button (B'NCE)...
- Sends the monitor path to the large matrix and disables the output of the channel path
- What does Upper C/O do?
- Changes the mic/line input against master status
- In Mix mode, the channel path is routed to?
- Large Fader and small Matrix
- Channel Output (CH/OP)
- Puts a post fader channel feed into the monitor path
- The "DYN" button in the EQ section of the module
- Puts the EQ into the side-chain of the compressor
- The insert can be assigned to
- The channel path and the monitor path
- In the EQ section, the "Hi Q" button(s)
- Changes the HF and/or the LF to a narrow, notch-shape EQ
- The group button on the input section of the module
- Makes the input to the channel path the corresponding group output
- In record mode, in order to send tape returns to the artists' headphones...
- Assign aux sends to the monitor path by the small fader of each module
- Which of the following CANNOT be assigned to the monitor path?
- Filters
- If you hit "chan safe" in the master section of the console
- Your channel is in AFL, your monitor is in SIP
- When you have "Follow Mon" selected in the multitrack meters section, and "O/P" selected on multitrack monitors...
- You will see and hear tape sends
- To set input levels on the Neve V3
- Select PFL solo mode and O/P on multitrack meters, then use the master meters to view level
- Hysteresis
- Is the difference between the opening and closing threshold on the gate
- How do you get a fast attack on the compressor?
- Pull the Ratio Knob
- How do you turn on phantom power?
- Push the mic knob
- The direct button
- Sends the channel signal directly to the corresponding group output, bypassing the matrix
- If you have assigned multiple modules to one group output, how do you increase or decrease the overall output gain?
- Using the group trim knob on the corresponding module
- Linking two compressors
- Sums the control voltages, but the settings are not linked
- You can use the small fader in Mix mode as an additional aux send.
- True
- It is not possible to put the Insert before the EQ and Dynamics
- False
- The phase button affects the channel path if its input is set to group
- False
- It is not possible to view your tape returns and your group output levels at the same time on the multitrack meters.
- True
- Hitting Lower C/O while in Mix mode
- Sends Channel Signal to large matrix
- Group overrides mic and line input to the channel path
- True