34 Foot Boat Study Guide
Terms
undefined, object
copy deck
- Characteristics of the HULL are?
-
1. Planing type.
2. Paint is valspar Urethane. It is not Anti Foul CAUTION Do not use Mercury or Copper based paints on this hull as severe corrosion will result. - SPECS
-
Length-37Ft. 11 in. (Overall)
Height-13Ft. 7 in. (Mast all the way down.)
Beam-Beam 11 Ft. 11 1/2 in.
Draft-4Ft.
Weight-17,000 (W/out trailer) 20,000 (W/trailer)
Tactical Diameter 55 Ft. (Approx). -
Engine Type, and HorsePower?
What type of shutdown?
What type of fuel? -
1. 6BTA M2 Cummins, B-Series, 6 cylinder aftercooled, Turbocharged, Marine/Seawater cooled.
2. 370 HP. 5.9 liter.
3. Manual fuel shutdown.
4.#2 Diesel or better. -
What is the operating temp?
What is the Max temp? -
Operating-181-203.
Max- 205 degs. - How many gallons of fuel is used per hour at cruise speed?
- 17 gallons per hour
- What is the firing order?
- 1-5-3-6-2-4
- what is the idle speed?
- 750 rpm.
- What is the Direction of rotation?
- Clockwise from the front of the Engine.
- Does it have a Heater?
- Yes-Has engine heater.
- Out Drives
-
Konrad 520 (opposite rotation)
No shifting of gears - What is the quart capacity of the Out Drives?
- 7 Quart capacity. Note: (Must use synthetic 75-90W in water cooler than 60 degs.
- How can you fill?
-
Can fill from top or drain hole.
Has site glass for level mounted on transom. - Where are the warning lights for the Out Drives located?
- Warning lights by tilt and trim switches to show unsafe angle or low oil (Max 8 Degs)
- Transmission Type?
-
1. Twin disc model MG 5075
2. 1.32 Gal of 40W. - How can you drain and change trans and engine oil?
- You can change trans and eng oil thru pump system.
- Transmission characteristics.
- Clutch disc hydraulic pressure (dash guard should be between 40 psi (idle in gear) and 350 psi (Cruising).
- Max shift rpm?
- 1000 rpm. CAUTION Severe damage to Trans/Outdrive may result with speed shifting.
- When will the Trans high oil temp go off?
- Switch goes off at 205 Degs. (+/-2 degs.)
- After Cooler?
-
1. Increases the density of the hot compressed air by cooling it down.
2. Finned shell and tube type. - Air/Turbo System?
-
1. Turbo is pressured lubricated by lube oil system.
2. Turbine is driven by exhaust gasses.
3. Compressor side compresses air to increase air flow.