Cosmetology-Haircutting
Terms
undefined, object
copy deck
- when the hair is combed away from its natural falling position
- what is over directing the hair?
- cutting the hair at an elevation of 90 degrees and above
- a layered look is preformed by:
- exposing the scalp
- The result from cutting thin hair too short is ________.
- to remove bulk from hair
- What is the purpose of using thinning shears?
- the ends of the hair are cut at an angle
- The 'softer and feathering' appearence of a razor cut is produced from a razor cut is due from.......
- the fringe
- what is the triangular section that starts at the of the apex and ends at the corners?
- a haircut with uniform or increasing layers
- When you cut 'on top of your fingers' or 'on top of your knuckles' you are most likely creating...
- reference points
- The areas on the head such as the ears and jawline are consider what points?
- clippers
- When creating a flat top you should use what tool?
- texture
- A hair strand's diameter determines the ______.
- the angle that the subsection of hair is held from the head when being cut
- Elevation is..
- beveling
- What technique creates fullness by the hair ends being cut at a slight taper?
- make vertical partings
- If using horizontal partings in a hair-cut, how would a cross-check be preformed?
- the removal of weight
- Elevating the hair at 90 degrees or above will result in...
- The tang on the shears is also known as
- Finger brace
- palming the shears
- Curling the fingers around is shears while combing or parting hair is called...
- the growth pattern
- the natural fall of the hair is called?
- fringe
- The area of the hair that lies between the outer corners of the eyes is known as the ______.
- blended, not blended
- When creating bangs, the hair in the fringe area can either be _____ and ______.
- crown and neckline
- Which areas on the head have the strongest growth pattern?
- to allow the stylist to cut short and close to the head
- whats the purspose of the barber comb?
- removing excess weight without affecting the length
- The term texurizing means...
- keep shears partially open while one slides shears againest the hair
- Slide Cutting
- the hair is wet in some areas and dry in others
- A stylist make get uneven results in a haircut if...
- texture
- The behavior of hair is based on density, wave pattern, growth pattern hairlines and _____.
- clippers over comb
- when you slide the clippers across the comb side ways, this is called...
- 1/4 to 1/2 inches longer
- when you cut hair that is not curly, how much longer should you cut it from the desired length?
- swept up hair off of the floor
- Before blowdrying what should you make sure you have done?
- a razor
- What cutting tool creates frizz to curly hair?
- holding
- When cutting hair, there is a dominate hair and a ______ hand.